Limitation Of Liability; Safety Precautions Volta 500; Risk Of Unsafe Operation; Shock Hazard Warning - Stage Zero Volta 500 User Manual

1.2 Limitation of Liability

Stage Zero shall not be held responsible for damages of any kind, including – without limitation,
Ø bodily harm.
Ø injury or damage to property.
In connection with the handling of the Volta 500 unit.
o
System installation.
o
Or compliance or non-compliance with the instructions set forth in this manual.
o

2 Safety Precautions Volta 500

2.1 Risk of Unsafe Operation

When using this Volta 500-unit, basic safety precautions should always be followed to reduce the risk of personal injury.
Improper operation, maintenance or modification of this Volta 500 unit could result in serious injury and property
damage. There are certain applications for which this Volta 500 unit is designed. Stage Zero stipulates that this Volta 500
product may not be modified and/or used for any application other than for which it was designed.

2.2 Shock Hazard Warning

Before attempting to install and operate the Volta 500 unit and other electrical equipment, all instructions should be
read and understood. Contact with electrically active parts of the Volta 500 unit, such as terminals, can result in injury or
death, irrespective of whether or not the Volta 500 unit and the other electrical equipment have been connected.

2.3 Li -Ion Battery Safety

The Volta 500 unit contains a
•
Do not put the Volta 500 Unit near external heat sources or in direct sunlight
•
Do not put batteries in contact with conductive materials, water, seawater, strong oxidizers, and strong acids.
•
Do not pack flammable materials around the Volta 500 unit.
If the Volta 500 unit emits smoke or unusual odours, please immediately disconnect the unit from the mains power
supply and from appliances/devices. Should a fire occur, use a DCP or CO2 type fire extinguisher. Do not use water.

2.4 General Safety

Before attempting to install, operate and / or replace the fuse on the Volta 500 unit, all instructions should be read and
understood. All other maintenance and repair requirements must be reported to the help line who will arrange for the
necessary work to be conducted.
Do not use or install damaged Volta 500 units.
Only the fuse may be replaced on this Volta 500 unit, Do not attempt to repair any other part of the Volta 500 unit.
Do not disassemble a Volta 500 unit or remove any Volta 500 unit's parts.
Keep all connectors clean and dry at all times and free from obstruction.
Do not expose the Volta 500 units and its connectors to any chemical substance. Store in a safe place away from oil,
lubricants etc.
Do not connect or disconnect units when current from the Volta 500 unit or an external source is present.
VOLTA 500
LiFePO4 battery. The following safety instructions must be followed;
4