Minelab X-TERRA PRO Instruction Manual page 45

General Troubleshooting
Distortion/crackling heard in Wireless Headphones when connected via Wireless
1. Ensure the headphones are within 1 metre (3 feet) of the detector Control Pod, with no obstructions between the
headphones and detector (including your own body)�
Detector is charging and the Charge Status LED is flashing, but the charge indicator is missing in the Status Bar
1. Check that you are charging from a USB charging source with a 2 A @ 5 V charging capacity�
2. If charging from a lower‑powered USB port (such as a laptop port), the detector may be discharging the battery at
a faster rate than it is charging� This prevents the charge indicator from appearing� Try charging with the detector
switched off�
3. Avoid using a USB extension cable when charging�
Speaker is squeaky or muffled after submersion in cold water
1. Allow up to 30 minutes for the detector internal air pressure to return to normal� Note, laying the detector on the
ground with the Control Pod standing up may equalise internal air pressure faster�
Headphone indicator is On, but no headphones are connected
There may be water inside the Headphone Socket causing false detection of wired headphones�
1. Check that the Headphone Socket is clear of water and obstructions�
2. If water is present, use a warm (not hot) air dryer to dry the Socket�
CONTENTS
(Continued)
45