Target Tone - Minelab X-TERRA PRO Instruction Manual

Target Tone

The Target Tone Setting controls the number of
different tones you will hear for different types
of targets�
Target Tone allows you to divide the Target ID range into
separate Tone Regions� Therefore, you can hear more or
less target information�
The Target Tone setting has the options of 1, 2, 5, All Tones
(At) and Depth (dP)�
Target Tone adjustment is local; only the current Search
Mode Search Profile is affected by changes to this setting�
Choosing a Target Tone Setting
1 Tone
Target responses give long and short beeps of the same
pitch, regardless of their Target ID�
2 and 5 Tones
Target responses give long and short beeps in 2 or 5
different pitches depending on their Target ID�
All Tones (At)
Target Responses give long and short beeps with a
different pitch for every Target ID�
Depth (dP)
Target Responses vary in pitch and volume proportional to
the target signal strength� All targets increase in volume
proportional to the target signal strength, therefore large
or shallow targets will sound louder than small or deep
targets�
Conductive targets increase in pitch, and ferrous targets
have a constant low‑pitch�
Loud,
Loud, very Loud, high ferrous
high tone tone tone
Shallow or large targets give a
stronger signal
Small or deep targets give a
weaker signal
CONTENTS
Quiet,
Quiet, Very quiet, ferrous
low tone low tone tone
Change the Number of Target Tones
1. Press the Settings button to navigate to Target Tone�
2. Use the Minus (–) and Plus (+) buttons to select the
new Target Tone setting: 1, 2, 5, All Tones (At), or
Depth (dP)�
The setting is indicated on the Target ID Number�
1 Tone 2 Tones 5 Tones
Target Tone Dependencies
When the Target Tone setting is changed, the options for the
following Advanced Settings also change:
Tone Volume
ƒ
ƒ Tone Break
For this reason, we recommend choosing your Target Tone
setting before you begin adjusting the Tone Volume and
Tone Break settings�
29
All Tones Depth