Cleaning And Maintenance - Midea AC4023R User Manual

CLEANING AND MAINTENANCE

Notice
• Disconnect the power before cleaning the product. Clean after the product is shut
down for two minutes.
• Prevent from using any abrasive tools and solvents that may damage the surface to
clean up the product. Detergent can be used in the cleaning, and then wiped clean with
dried cloth in time.
EN
• Prevent from washing the machine body with water directly, and wash disassemble
parts (wet curtain parts) with a soft brush and then install them after they are cleaned
and dried.
• It is not allowed to take the product apart for any modification. It is recommended that
this product should be checked and cleaned regularly in order to extend its service life.
Replace Water
After stopping the cool wind function for 2 minutes, it's applicable to pull out the water
tank to replace water, as water in the pipeline and wet curtain flows back to the water
tank.
The fan requires minimal maintenance. Do not try to fix it by yourself. Please contact
with Midea customer service center if service needed.
1. Before cleaning and assembling, unplug the fan power.
2. To ensure adequate air circulation to the motor, keep vents at the rear of the motor free
of dust. Do not disassemble the fan to remove dust.
Please wipe the exterior parts with a soft cloth soaking a mild detergent.
3.
Do not use any abrasive detergent or solvents to avoid scratching the surface.
4. Do not use any of the following as a cleaner: gasoline, thinner.
5. Do not allow water or any other liquid entering into the motor housing or interior parts.
6. Be sure to unplug from the electrical supply source before cleaning.
7. Plastic parts should be cleaned with a soft cloth moisten with mild soap Thoroughly
remove soapsuds with dry cloth.
Stop the cool wind
function for 2 minutes.
15