English • To guarantee the smooth running of the thermostat, it Safety Notes is necessary from time to time to turn the thermostat Gloves should be worn during installation to prevent from total hot to total cold. crushing and cutting injuries. Dimensions (see page 15) The product may only be used for bathing, hygienic and body cleaning purposes. Flow diagram (see page 15) Children as well as adults with physical, mental and/ free flow or sensoric impairments must not use this product Spare parts (see page 16) without proper supervision. Persons under the influence of alcohol or drugs are prohibited from Special accessories (see page 17) using this product. The hot and cold supplies must be of equal order as an extra pressures. • extension 25 mm #13595000 Installation Instructions • Extension Set 22 mm (when wall is not deep • Prior to installation, inspect the product for transport enough)#13593000 damages. After it has been installed, no transport or • Extension Set 22 mm (when wall is not deep surface damage will be honoured. enough) #15597000 • The pipes and the fixture must be installed, flushed and tested as per the applicable standards.
Page 5
English Fault Cause Remedy Insufficient water - Supply pressure inadequate - Check water pressure (If a pump has been installed check to see if the pump is working). - Regulator filter dirty - Clean filter in front of the mixer and on the MTC-thermo cartridge - Shower filter seal dirty - Clean filter seal between shower and hose - filter insert shower dirty - Clean filter insert between shower and hose Crossflow, hot water being forced - Backflow preventers dirty or - Clean backflow preventers, into cold water pipe, or vice versa, leaking exchange if necessary when mixer is closed Spout temperature does not - Thermostat has not been adjusted - Adjust thermostat correspond with temperature set - Hot water temperature too low - Increase hot water temperature to 42 ºC to 60 ºC Temperature regulation not possible - thermo cartridge calcified - Exchange thermo cartridge - For new installations: basic body - Install function block turned through incorrectly connected (should be: 180º cold right, hot left) or installed with 180º rotation Safety stop button not operating - Spring defective...
English • After cleaning rinse thoroughly with clean water to Cleaning Recommendation for Hans- remove any cleaner residue. grohe Products • The use of steam cleaners is not permitted. The high Today, modern sanitary and kitchen tapware, showers, temperatures can damage the products. accessories, washstands, tubs and radiators consist of Important very different materials to comply with the needs of the...