Swapping Fiber Connector; Figure 3-3 Lc/Pc Fiber Connector - Huawei BYPASS OP9000 Manual

BYPASS OP9000
Performance and Features

Figure 3-3 LC/PC fiber connector

3.3.2 Swapping Fiber Connector

Before connecting optical fiber, please clean up the optical connector to avoid
attenuation increase, which may lead to bit error and even service interruption.
Insert Fiber Connector
The LC/PC fiber connector can be inserted directly by hand.
Step
Please keep the dust cap for future use to protect the connector against dirt and dust.
Pulling Out Fiber Connector
The LC/PC fiber connector can be directly pulled out by hand. However, if the
optical fibers are distributed densely, a dedicated optical fiber extractor shall be
used.
Step
Document Version
T2-0416xx-20050330-C-1.20
(March 2005)
Warning
Action
1 Take off the dust cap from the connector and clean the optical connector.
Align the LC/PC connector to the board optical interface; Push the connector
2
gently in along the guide rail until it clicks.
Note:
Action
Clamp the fiber connector from the up and down sides by hand or with optical
1
HUAWEI TECHNOLOGIES CO.,
LTD.
3 Working Principle and Functions
- 3-9 -