H3C S5590-HI Series Manual page 20

Table3-2 Expansion card and expansion slot compatibility for the S5590-48T4XC-HI and
S5590-48S4XC-HI switches
S5590-48T4XC-HI
S5590-48S4XC-HI
Expansion
card
Expansion slot 1
mode0
LSPM6FWD Supported
Not
LSWM2EC
supported
LSWM2QP2
Supported
P
LSWM2SP2 Not
PB supported
LSWM2SP4 Not
PB supported
LSWM2SP8 Not
P supported
LSWM2ZQP Not
2P supported
LSWM2ZSP Not
8P supported
The power supplies support asset management. You can use the
command to view the name, sequence number, and vendor of the power supply you have installed
on the switch.
For non-PoE switches, you can install one power supply, or two power supplies for 1+1 redundancy
on the switch.
For PoE switches, you can install one power supply, or two power supplies for 1+1 redundancy on
the switch. PoE capabilities vary by power supply configuration. When a power supply fails, PoE
capabilities of the switch might decrease. For more information about PoE power capacity, see
Table1-5.
The switch uses removable fan trays. Do not power on the switch if it does not have two fan trays of
the same model installed.
For the S5590-48T4XC-HI and S5590-48S4XC-HI switches, you can use the
command to configure the port rate mode for an expansion slot. By default, the port rate mode for an
expansion slot is mode0. To have the configuration take effect, you must save the configuration and
restart the switch. For more information about the
interface commands in the command reference for the switch.
The S5590-28P8XC-EI (LS-5590-28P8XC-EI-GL), S5590-48P6XC-EI (LS-5590-48P6XC-EI-GL),
S5590-28S8XC-EI (LS-5590-28S8XC-EI-GL), and S5590-48S4XC-EI (LS-5590-48S4XC-EI-GL)
switches support shipping with fan trays and power supplies installed. For the switch to be shipped
with fan trays or power supplies installed, contact the marketing staff.
mode1 mode2
Not
Supported
supported
Supported Supported
Not
Supported
supported
Supported Supported
Supported Supported
Not
Supported
supported
Not Not
supported supported
Not Not
supported supported
Expansion slot 2
mode0 mode1
Supported Supported
Supported Supported
Supported Supported
Supported Supported
Supported Supported
Supported Supported
Supported Supported
Supported Supported
display device manuinfo
port-speed-mode
mode2
Supported
Supported
Supported
Supported
Supported
Supported
Supported
Supported
port-speed-mode
command, see Ethernet