Advertisement
4. Wiring diagram
4.1 Electrical lock wiring diagram
4.11. Connection of the electric lock without additional power supply.
Note: At
of up to 5 m of the entrance station and the electric lock, it is not
a distance
necessary to use an additional power supply of the lock.
Fig.1
(1) Supported door locks:
A: NC (normally closed) lock,turn off to unlock. DC12V lock support 0.35 A (Max).
B: NO(normally open)lock, on unlocks. DC12V lock support ≤2 A (Instant).
(2) Jumper settings: As shown in Figure 1.
(3) Set the type and time of unlocking the lock:
In the main menu of the 2-wire internal monitor in "Settings", select the option "Device
configuration",
go to the "List of entry stations" to mark the door station, in the menu "Add to the list of
monitoring devices" select "Edit" , enter the correct password and enter the modification
interface.
Select the lock type and set the unlock parameters "Alarm Status" to "On" or "Off" and the
required time in the "Unlock Time" menu.
Door station
Hex wrench
Screws
Dowle
1pc
1pc
4pc
4pc
Advertisement
