Advertisement
Noise i i n the drain hose
Foam
Fuse blown, or the
Replace fuse or reset circuit breaker. Remove any other
circuit breaker acted
appliances sharing the same circuit with the dishwasher
Power supply is not
Make sure the dishwasher is turned on and the door is
turned on
closed securely.
Make sure the power cord is properly plugged into the
wall socket.
Error code:E1;
Check that the water supply is connected properly and
Water pressure too low
the water is turned on.
Door of dishwasher is
Make sure to close the door properly and close it.
not properly closed.
Check drain hose.
Filter clogged
Check coarse the filter
(see section titled " Cleaning The Filter ")
Kitchen sink clogged
Check the kitchen sink to make sure it is draining well.
If the problem is the kitchen sink not draining ,you may
need a plumber rather than a serviceman for dishwashers.
Improper detergent
Use only the special dishwasher detergent to avoid
foam. If this occurs, open the dishwasher and let the foam
evaporate. Add 1 gallon of cold water to the tub. Close
and latch the dishwasher, then Start the "soak" wash
cycle to drain out the water . Repeat if necessary.
Spilled rinse-aid
Always wipe up rinse-aid spills immediately.
Detergent with
colourant was used
Hard water minerals
To clean the interior, use a damp sponge with
dishwasher detergent and wear rubber gloves.
Never use any other cleaner than dishwasher
detergent for the risk of foaming or suds.
The affected items are
not corrosion resistant.
A spray arm is
Interrupt the programme, and rearrange the items
knocking against
which are obstructing the spray arm.
an item from the basket
Interrupt the programme,
Items of crockery
are loose in the
and rearrange the crockery.
wash cabinet
This may be caused
This has no influence on the dishwasher function.
by on-site installation
if in doubt, contact a suitably qualified plumber.
or the cross-section of
the piping.
16
Make sure that the detergent used is without colourant.
Advertisement
