Advertisement
1
Draw out the lower and upper basket, load the dishes then push them back.
It is recommended to load the lower basket first, then the upper one (see the section entitled
Loading the Dishwasher
2
Pour in the detergent (see the section entitled
3
Insert the plug into the socket. The power supply is 220-240 VAC /50 HZ, the specification of the
socket is 10A 250VAC. Make sure that the water supply is turned on to full pressure.
4
Close the door, press the ON/OFF button, and the ON/OFF light will turn on. Turn the program
knob to select a desired wash cycle and then press the Start/Reset button; the dishwasher will begin
to work.
The program lights show the state of the dishwasher:
a) All program lights off---------------stand by
b) One of the program lights on----------pause
c) One of the program lights blinking----- run
Changing a programme
Premise:
1
A cycle that is underway can be modified only if it has been running for a short period of
time. Otherwise, the detergent may have already been released, and the appliance may
have already drained the wash water. If this is the case, the detergent dispenser must
be refilled (see the section entitled " Loading the Detergent " ).
2
When you press the start/reset button more than 3 seconds, you can cancel the running
programme and select other programmes (see the section entitled " Starting a wash cycle. . . " ).
I f you open the door during a wash cycle , the machine will pause and buzz every minute
.
unless you close the door and continue washing.
A forgotten dish can be added at any time before the detergent cup opens.
1
Open the door a little to stop the washing.
2
After the spray arms stoped working, you can open the door
completely.
When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off
the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they
are still hot and more susceptible to breakage. They will also dry better.
Switch Off the Dishwasher
The program has ended, only if there appears a 0 in the digital display (remaining program time).
1. Switch off the dishwasher by pressing the ON/OFF
button. 2.Turn off the water tap!
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes
before removing them from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal the dishwasher to be wet inside.
Empty the lower basket first and then the upper one. This will prevent water dripping from the upper basket onto
the dishes in the lower one.
).
It is dangerous to open the door when washing, as hot steam or water may come out.
Salt, Detergent and Rinse Aid ).
3
Load the forgotten dishes.
4
Close the door, press the start/reset button, the dishwasher
will start running again after 10 seconds.
10
Advertisement
