Advertisement
Remarks:
- Inspect the filters to prevent blocking every time after the dishwasher has been used.
- By unscrewing the coarse fi lter, you can remove the filter system. Remove any food remnants and
clean the fi lters under running water.
Th e en ti r e f i l t er as s em bl y s h ou l d b e cl e an e d o n ce a w ee k .
C l ea ni ng th e Fi l te r
To clean the coarse fi lter and the f ine f ilter, use a cleaning brush. Reassemble the fi lter parts as shown in the figures
on the previous page and reinsert the entire assembly in the dishwasher, positioning it in its place then press downwards.
The control panel can be cleaned by using a lightly dampened cloth.
After cleaning, make sure to dry it thoroughly.
For the exterior, use a good appliance polish wax.
Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.
C l ea ni ng T he Do or
Protecting Against Frost
Please take frost protection measures for the dishwasher during winter times. After each completed wash cycle,
please operate as follows：
1.
Switch off the electrical power to the dishwasher.
2.
Turn off the water supply and disconnect the water inlet pipe from the water
valve. 3.Drain the water from the inlet pipe and water valve. (Use a pan to catch the
water) 4.Reconnect the water inlet pipe to the water valve.
5.Remove the filter at the bottom of the tub and use a sponge to soak up water in the sump.
If your dishwasher cannot work because of the ice, please contact professional service persons.
It is recommended to clean the spray arms regularly as hard water chemicals can clog the spary arm jets and bearings.
When cleaning the filters, don't knock on them. Otherwise, the filters could be
contorted and the performance of the dishwasher could be decreased.
To clean the edge around the door, you should use a soft , damp cloth.
To avoid water entering into the door lock and electrical components, do not
use a spray cleaner of any kind.
Never use a spray cleaner to clean the door panel as it may damage the door lock
and electrical components.
Abrasive agents or some paper towels should not be used because of the risk of
scratching or leaving spots on the stainless steel surface.
12
Advertisement
