Nuvo NV-LRC1 Installation Manual page 30

*********************************************************************************
COMMAND: *ZxxMTOFF<CR> zone xx MUTE OFF (returns zone output to currently connected source at previous volume
setting).
RESPONSE: Same response as for *ZxxCONSR<CR>
*********************************************************************************
COMMAND: *ZxxBASSyyy<CR> zone xx BASS EQ with yyy = EQ level, dB, 12 to +0 (flat) to +12 in 2 dB increments.
USE LEAD "0" IN TENS PLACE FOR VALUE LESS THAN 10.
RESPONSE: Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the E6D will override the non-volatile BASS setting (set from keypad) for this zone until power
is cycled.
*********************************************************************************
COMMAND: *ZxxTREByyy<CR> zone xx TREBLE EQ with yyy = EQ level, dB, 12 to +0 (flat) to +12 in 2 dB increments.
USE LEAD "0" IN TENS PLACE FOR VALUE LESS THAN 10.
RESPONSE: Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the E6D will override the non-volatile TREBLE setting (set from keypad) for this zone until
power is cycled.
*********************************************************************************
COMMAND: *ZxxGRPON<CR> zone xx SOURCE GROUP ON.
RESPONSE: Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the E6D will override the non-volatile GROUP setting (set from keypad) for this zone until
power is cycled.
*********************************************************************************
COMMAND: *ZxxGRPOFF<CR> zone xx SOURCE GROUP OFF.
RESPONSE: Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the will override the non-volatile GROUP setting (set from keypad) for this zone until power is
cycled.
*********************************************************************************
COMMAND: *ZxxVRSTON<CR> zone xx VOLUME RESET ON.
RESPONSE: Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP
switches) for this zone until power is cycled.
*********************************************************************************
COMMAND: *ZxxVRSTOFF<CR> zone xx VOLUME RESET OFF.
RESPONSE: Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP
switches) for this zone until power is cycled.
*********************************************************************************
COMMAND: *ZxxLKON<CR> zone xx KEYPAD LOCK ON This will INHIBIT ANY keypad control input on the zone. This is
the same as activating the Parental lock control at a keypad by holding down a SOURCE key for three
seconds).
RESPONSE: #ZxxLKON<CR>6
27