Nuvo NV-LRC1 Installation Manual page 27

NOTE: the Main Unit ships with the carrier frequency DEFAULT setting of 38 KHz for all six sources.
*********************************************************************************
COMMAND: *IRSETDF<CR> Restores DEFAULT SOURCE IR carrier frequency settings (38 KHz for all six sources).
RESPONSE: Same response as for #IRSETSR<CR>
*********************************************************************************
COMMAND: *SxIR56SET<CR> - sets SOURCE x to 56 KHz IR repeat carrier (x is 1 to 6).
RESPONSE: Same response as for #IRSETSR<CR>
*********************************************************************************
COMMAND: *SxIR38SET<CR> - sets SOURCE x to 38 KHz IR repeat carrier (x is 1 to 6).
RESPONSE: Same response as for #IRSETSR<CR>
*********************************************************************************
COMMAND/RESPONSE DESCRIPTIONS.
NOTE zone number field xx should ALWAYS include a lead zero ("0") for zone numbers less than 10.
COMMAND: *ZxxCONSR<CR> - Connect STATUS REQUEST where xx is zone # from 1 to
RESPONSE: #ZxxPWRppp,SRCs,GRPt,VOL-yy,Pzzz<CR>
The remaining fields are not included in the response if ppp is "OFF":
This response will also be issued in response to pressing the ON/OFF, VOLUME, or SOURCE
keys on a KEYPAD. NOTE the response will be issued if a SOURCE key is pressed on a
zone that is powered OFF even though the key press has no effect on the system. It will be
output at every increment during a volume ramp initiated by HOLDING a VOLUME UP or
VOLUME DOWN key on a keypad. It will also be issued at every increment of a volume
ramp commanded by the *ZxxVOL+<CR> and *ZxxVOL-<CR> commands (see below).
The MUTE value will be asserted if a *ZxMTON<CR> command has been received, OR if the
volume is run all the way to the lowest possible point (volume off). An active EXTERNAL
12.
-s = SOURCE NUMBER 1 to 6
-q = 0 if SOURCE GROUP is ON 1if SOURCE GROUP is OFF
-yy = level below max in dB: -00 to -78 dB
values)
-yy = "MT" if in MUTE state
-yy = "XM" if external MUTE is being held
active
-zzz = "MST" if this zone is PARTY MASTER
-zzz = "SLV" if this zone is SLAVED to a
PARTY MASTER in another zone
-zzz = "OFF" if this zone is under LOCAL CONTROL only (either there is no
party master, or this zone has been manually
overridden)
-ppp = "ON" (2 characters)
or "OFF" (3 characters)
24
(include lead 0 for all single-digit