Command to determine when the desired volume point has been reached. Note that ramps in different zones may start at
different levels and will all ramp at the same rate.
*********************************************************************************
COMMAND:
*ALLV-<CR> Ramp ALL zones DOWN at a 10 dB/second rate in 1 dB steps.
RESPONSE:
#ALLV-<CR>
The ramp action will be cancelled when all zones reach MINIMUM (OFF) volume, or when an *ALLHLD<CR> Command is
received. Note that to stop the ramp with this command before the minimum volume, one reference zone must be periodically
polled with a *ZxxCONSR<CR> Command to determine when the desired volume point has been reached. Note that ramps in
different zones may start at different levels and will all ramp at the same rate.
*********************************************************************************
COMMAND:
*ALLHLD<CR> Stops ramp action initiated by *ALLV+<CR> Or *ALLV-<CR>
RESPONSE:
#ALLHLD-<CR>
This results in a HOLD of the level at time of command receipt.
*********************************************************************************
COMMAND:
*ALLMON<CR> ALL MUTE ON.
RESPONSE:
# ALLMON<CR>
*********************************************************************************
COMMAND:
*ALLMOFF<CR> ALL MUTE OFF.
RESPONSE:
#ALLMOFF<CR>
********************************************************************************
COMMAND:
*ZxxSRCp<CR> Switch zone xx to SOURCE p ( 1 to 6).
RESPONSE:
Same response as for *ZxxCONSR<CR>
*********************************************************************************
COMMAND:
*ZxxVOLyy<CR> Set volume of zone xx to level yy below max in dB from 0 to 78 dB (include lead 0 for all
single-digit values).
RESPONSE:
Same response as for *ZxxCONSR<CR>
*********************************************************************************
COMMAND:
*ZxxVOL+<CR> STARTS zone xx volume ramp UP at the rate of +10 dB per second in +1 dB steps. (This is
the same as holding VOLUME UP key on a KEYPAD for 1 second).
RESPONSE:
Same response as for *ZxxCONSR<CR>, updated 10 times per second.
*********************************************************************************
COMMAND:
*ZxxVOL-<CR> STARTS zone xx volume ramp DOWN at the rate of -10 dB per second in -1 dB steps. (This
is the same as holding VOLUME UP key on a KEYPAD for 1 second).
RESPONSE:
Same response as for *ZxxCONSR<CR>, updated 10 times per second.
*********************************************************************************
COMMAND:
*ZxxVHLD<CR> STOPS zone xx volume ramp initiated by *ZxxVOL++<CR> or *ZxxVOL--<CR> commands.
This results in a HOLD of the level at time of command receipt.
RESPONSE:
#ZxxVHLD<CR>
*********************************************************************************
COMMAND:
*ZxxMTON<CR> zone xx MUTE ON (mutes currently connected source)
RESPONSE:
Same response as for *ZxxCONSR<CR>
26