Dometic DELIBOX DEL90H Installation And Operating Manual page 4

EN
DEL90HC only
WARNING! Explosion hazard
Do not store any explosive substances, such as spray cans with propellants, in the device.
CAUTION! Electrocution hazard
• Disconnect the device from the power supply before each cleaning and maintenance.
• Disconnect the device from the power supply after every use.
WARNING! Fire hazard
• Switch off the device in the event of any damage to the refrigerant circuit.
• Avoid naked flames and sparks in the event of any damage to the refrigerant circuit.
• Air ventilate the room well in the event of any damage to the refrigerant circuit.
• Keep the ventilation openings on the device housing free of obstructions.
• Do not damage the refrigerant circuit.
• Do not use electrical devices in the food compartments of the cooler unless they are recommended
by the manufacturer for this purpose.
• Do not place any caustic materials or materials containing solvents in the device.
WARNING! Health hazard
• Children aged from 3 to 8 years allowed to load and unload the appliance.
• Check if the cooling capacity of the device is suitable for storing the food you wish to cool.
• Check if the heating capacity of the device is suitable for storing the food you wish to heat.
• Opening the door for long periods can cause significant increase of the temperature in the compart-
ments of the device while the cooling mode is on.
• Opening the door for a longer period can cause a significant decrease temperature in the compart-
ments of the device while the heating mode is on.
• Switch off the device if it is le empty for a long period.
• Defrost the device if it is le empty for a long period.
• Clean and dry the device if it is le empty for a long period.
• Leave the door open to prevent mold developing within the device if it is le empty for a long peri-
od.
NOTICE! Damage hazard
• Do not open the refrigerant circuit under any circumstances.
• Only carry the device upright.
• Do not place the device near naked flames or other heat sources (heaters, direct sunlight, gas ovens
etc.).
• Check that the voltage specification on the data plate is the same as that of the power supply.
4