Table of Contents
Advertisement
– Positioning
– Electrical connection
– Appliance cleaning, repair and extraordinary maintenance
– Appliance disposal
– Work on electrical equipment
– Dismantling operations of appliances which use R290 or R-744 (with a refrigeration system under high pressure)
– Dismantling operations of appliances which use flammable insulation blowing gases;
A.5
Safety signs to be placed on the appliance or near its area
Prohibition
Danger
A.6
Residual risks
The appliance has several risks that were not completely eliminated from a design standpoint or with the installation of adequate
protection devices. Nevertheless, through this manual the Manufacturer has taken steps to inform operators of such risks, carefully
indicating the personal protection equipment to be used by them. In order to reduce the risks, provide for sufficient spaces while
installing the unit.
To preserve these conditions, the areas around the appliance must always be:
• kept free of obstacles (e.g. ladders, tools, containers, boxes, etc.);
• clean and dry;
• well lit.
For the Customer's complete information, the residual risks remaining on the appliance are indicated below: such actions are
deemed improper and therefore strictly forbidden.
Residual risk
Slipping or falling
Burns/abrasions (e.g. heating elements, cold
pan, cooling circuit plates and pipes)
Electrocution
Falling from above
Crushing or injury
Tipping of loads
Chemical (refrigerant gas)
Sudden closing of the door/drawers (if present,
depending on the appliance type)
A.7
Technical data
• The data plate and the energy labelling refer to original manufactured configuration.
• The appliance that can operate at 50 Hz or 60 Hz does not need any setting by the user.
22
Meaning
do not remove the safety devices
do not use water to extinguish fires (placed on electrical parts)
Meaning
caution hot surface
danger of electrocution (shown on electrical parts with indication of voltage)
Description of hazardous situation
The operator can slip due to water, any liquid or dirt on the floor
The operator deliberately or unintentionally touches some components
inside the appliance without using protective gloves.
Contact with live parts during maintenance operations carried out with the
electrical panel powered
The operator intervenes on the appliance using unsuitable systems to
access the upper part (e.g. rung ladders, or climbs on it)
The specialised personnel may not correctly fix the control panel when
accessing the technical compartment. The panel could close suddenly.
When handling the appliance or the packing containing it, using unsuitable
lifting systems or accessories or with the unbalanced load
Inhalation of refrigerant gas. Therefore always refer to the appliance labels
The operator for normal appliance use could suddenly and deliberately
close (if present, depending on the appliance type):
• door/s
• drawers
Advertisement
Table of Contents
