Wall Fixing; Wheel Rotation Lock Brackets; Appliance Space Limits; Appliance Disposal - Electrolux ecostore 727419 Installation Manual

• For the choice of remote condensing unit refer to the unit recommended by the Manufacturer, given on the equipment technical
sheet.
• In case of extraordinary size of the remote condensing unit refer to the technical sheet for the refrigerating capacity data or
consult the Manufacturer's website or Local Service Center/ Agency authorized by the Manufacturer.
• In appliance with R-744 as refrigerant, a pressure relief device shall be installed in the high pressure side of the refrigeration
system between the motor-compressor and the gas cooler. There shall be shut off devices or other components except piping
between the motor-compressor and the pressure relief device that could introduce a pressure drop.
• The pressure relief device shall be mounted so that any refrigerant released from the system during its operation can not cause
harm to the user of the appliance. The aperture shall be located so that it is unlikely to be obstructed in normal use.
• The installed pressure relief device shall have no provisions for setting by the end user.
• The pressure setting of the installed pressure relief device shall be no higher than the design pressure of the high-pressure side.
• For any fine-tune setting to the electronic valve parameters please refer to the service manual on the website.
• In case of "Marine" models, the appliances must be fixed to the floor.
• Prevent the areas where the appliance is installed to be polluted with corrosive substances (chlorine, etc.). The manufacturer
declines any liability for corrosive effects due to external causes.
A.16 Wall fixing
• When installing the glass door appliances with high feet make sure to fix the anti-tipping cables to it.
To fit proceed as shown in the paragraph E.6 Fitting anti-tipping cables on glass door models (2 module) with feet or wheels
A.17 Wheel rotation lock brackets
IMPORTANT
On all V2MMTNHC - V2MMTNMHC and V2MMTN models with high wheels, install the wheel rotation locking bracket
accessory included in the appliance, according to the installation instructions.
A.18 Appliance space limits
• Appliances with standard ventilation: make sure to position the appliance at least 500 mm from the top, 30 mm from the back,
20 mm (for refrigerated models) and 30 mm (for freezer models) from any other machines present in the room (in fact, close
proximity can create problems of condensate forming on the walls of the appliance), also taking into consideration the space
needed for door opening. For 3-doors models make sure to position the appliance at least 500 mm from the top, 100 mm from the
back, 20 mm from any other machines present in the room. Appliances with frontal ventilation (Marine models): make sure to
position the appliance at least 105 mm (for 1MTN-2MTN models) and 200 mm (for 2MBT model) from the top, 30 mm from the
back, 20 mm from any other machines present in the room.
A.19 Appliance disposal
• Make the appliance unusable by removing the power cable and any compartment closing devices, to prevent the possibility of
someone becoming trapped inside.
B APPLIANCE AND MANUFACTURER'S IDENTIFICATION DATA
The data plate gives the product identification and technical
data.
An example of the marking or data plate on the appliance is
given below:
xxxxxxxxx
F.Mod. Comm.Model
xxxxxxxx xxxxxxxx
PNC 9VTX Ser.Nr.
xxx kW xxxx
W Tot. Volt
Potenza Sbrinamento / Defrost Power xxx
x
Resistenza Evaporazione / Evaporation Heater El.
x
Illuminazione / Lighting
IPxx
Electrolux Professional SPA - Viale Treviso, 15 - 33170 Pordenone (Italy)
The meaning of the various information given on it is listed
below:
F.Mod. factory description of product
Comm.Mod. commercial description
PNC production number code
Ser.No. serial number
Type ref. certification group of the appliance
Cyclopentane expanding gas used in insulation
C GENERAL INFORMATION
C.1

Introduction

This manual contains information relevant to various applian-
ces. The product images in this guide are only an example.
xxxxxxxxx xxxxxx
Type ref.
2019
Cyclopentane
xxx xx xx
Hz Total Current A
kW Classe / Class x GWP xxxx CO2-eq xxx t
xxxxx xx
kW Refrigerante / Refrigerant Kg
x
W Cap.
V power supply voltage
Hz power supply frequency
kW power input
A absorbed current
Evaporation evaporation heating element power
heater El.
Class climatic class
GWP global warming potential
CO2 eq quantity of greenhouse gases
Lighting internal light
Cap. nominal capacity
Refrigerant type of refrigerant gas
Defrost power current absorbed
CE marking
WEEE symbol
IP21 dust and water protection rating
The drawings and diagrams given in the manual are not in
scale. They supplement the written information with an outline,
but are not intended to be a detailed representation of the
appliance supplied.
25