Table of Contents
Advertisement
6) Run the auger system EMPTY before loading grain into the tank for actual use. Make certain that the slip clutch is operating and that
the upper and lower augers are properly engaged.
7) Connect the lighting 7-prong connector end on the main wiring harness to the tractor electrical outlet. Make sure that all flasher and
turn indicator lights are working properly before incidental highway travel.
CAUTION
•
Do NOT operate the grain cart before reading and understanding the Operator's Manual and ALL danger, warning and caution
signs.
•
Be sure that a Slow-Moving-Vehicle emblem is attached to the rear of the grain cart.
•
Never exceed 1,000 rpm on the PTO and driveline system.
•
Never fold or extend the auger until the PTO has come to a complete stop.
•
Never fill the grain cart unless the gate indicator is in the closed position.
•
Never allow foreign object (shovels, etc.) to be placed inside the grain cart.
•
Never engage the lugs and drive dogs on the augers when the system is moving at a high rate of speed.
•
Never perform maintenance work or service the grain cart with the tractor running.
Adjusting Row Spacing for Walking Tandem Duals
Figure A
Frame Weldment
1 3/4" x
13 1/2"
Bolt
30" Row
JACK
Spacing
1" x 7 1/2" Bolt
Figure B
Clamp Plate
Frame
Weldment
Slide Frame Weldment out
9" for 36" Row Spacing
Frame Weldment
Figure C
for Dual Wheels
For 36" row
spacing,
place
Frame
Weldment
9" from
edge of
Stop.
JACK
Operating Instructions
1) Securely position jacks under the frame of the grain cart as shown in Figures A and C.
2) Loosen the rear of the Frame Weldment by removing the 1" x 7 1/2" Gr 8 Bolts and
Clamp Plate.
3) Remove the 1 3/4" x 13 1/2" Bolt and Jam Nut from the front of the Frame Weldment.
4) Slide the Frame Weldment out to the bolt location for 36" row spacings as shown
in Figure A and secure using the 1 3/4" x 13 1/2" bolt and jam nut. If the grain cart is
equipped with an electronic scale system, be sure not to damage the electronic cord
36" Row
when moving the Frame Weldment.
Spacing
5) Swing the Frame Weldment outward. Switch the tire location by removing both
tires and remounting each tire to the hub on the opposite side of the weldment. The
tire originally on the outside of the weldment will now be located on the inside of
the weldment and vice versa. (The valve stems for 36" row spacing should be facing
toward the Frame Weldment, or toward each other.) Be sure to keep the tire tread
positioned in the same direction as before.
6) After the wheels have been tightened to the hubs, swing the Frame Weldment until
the new clamping location is 9" from the original 30" row spacing stop.
7) Tighten the rear of the Frame Weldment to the grain cart frame using the six 1" x 7
1/2" Gr 8 Bolts, Hex Nuts and Clamp Plate.
8) Torque all bolts to specifications and Repeat on Other Side.
15
Advertisement
Table of Contents
