BEMIS bioBidet BLISS BB-2000 User Manual
Hide thumbs
Also See for bioBidet BLISS BB-2000:
- Replacement manual (2 pages) ,
- Owner's manual (14 pages) ,
- Owner's manual (38 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for BEMIS bioBidet BLISS BB-2000
Summary of Contents for BEMIS bioBidet BLISS BB-2000
-
Page 2: Product Information
PRODUCT INFORMATION Important Safeguards Overview & Parts Wireless Remote Registration and Installation Resources GETTING STARTED Functions & Features INSTALLATION Installation Guide Questions? We’re here to help. MAINTENANCE 847.458.2334 Cleaning Tips support@biobidet.com Removing The Nozzle Tip www.biobidet.com Removing The BB-2000 Draining The Warm Water Tank Technical support and alternate Troubleshooting Guide fittings are available. - Page 3 PLEASE OBSERVE THE FOLLOWING PRECAUTIONS AND INSTRUCTIONS BEFORE INSTALLATION AND USE. • This product must be connected to a grounded 120V GFCI (Ground Fault Circuit Interrupt) outlet. Do not connect the power cord if it is damaged or broken. Do not plug the product into a loose electric outlet. •...
- Page 4 BB-2000 BB-2000 Parts List Side Control Panel T-Valve L-Valve (2) Nuts 1/2 Conversion Nut *Rubber washer inside *Rubber washer inside Operation LED Window Deodorizer (2) Cone Packings (2) Bolt Guides (2) Mounting Bolts Warm Air Dryer Drain/Quick Release Nozzle Bidet Hose Toilet Hose Catch Plate Seat Sensor...
-
Page 5: Remote Display
Remote Display Stop Button Rear Wash Front Wash Dryer Front Wash Rear Wash Remote Signal Battery Life Warm Air Dryer Turbo Wash Vortex Wash Deodorizer Water Temperature Nozzle Oscillation Warm Water Water Pressure Massage/Auto Wash Seat Temperature Dryer On/Off Heated Seat Deodorizer Nozzle Position Adjustable... -
Page 6: Functions And Features
Functions & Features Massage Press “Massage” during a wash cycle to activate a pulsating spray pattern. The Bliss BB-2000 is a bidet toilet seat designed for superior hygiene, Change the water pressure with the “High” or “Low” (+, -) buttons. comfort, and sustainability. - Page 7 Deodorizer Energy Saving Mode Press to turn the deodorizer on/off. When turned on, the deodorizer will Switch energy saving features on/off. Energy saver mode automatically automatically activate when seated to reduce odors, and remains active maintains the water and seat temperature at 89.6°F (32°C) while the seat is for 1 minute after standing up.
- Page 8 3. Install Catch Plate BEFORE INSTALLATION Place the catch plate and bolt guides over the mounting holes. Insert the mounting bolts through the guides, catch plate, and mounting holes. Slide the cone packing Do not plug the power cord in until installation is complete. and washers onto the bolts and fasten to secure the catch plate on the toilet.
- Page 9 5. Connect the Water Hoses Install the t-valve onto the toilet tank. Ensure the rubber gasket is properly seated inside the t-valve. Toilet Tank Connect the provided toilet hose to the water shut-off valve and t-valve. You may also use your existing toilet hose. Connect the bidet hose to the bidet seat and l-valve.
-
Page 10: Cleaning The Nozzle
Cleaning the Nozzle Cleaning the BB-2000 • Hold the “Rear Wash” When you clean this product, do not use thinner, benzene or toilet bowl button on the side panel for cleaner, as it may cause discoloration or damage. 3 seconds without occupying •... - Page 11 Removing the Nozzle Tip Draining the Warm Water Tank Rubber Gasket *Close shut-off valve *Be careful not to lose the rubber gasket located inside the nozzle tip. Turn the nozzle tip counter clockwise to remove, or clockwise to secure it back in place. Removing the BB-2000 Before draining, unplug the power cord and wait 30 minutes until the unit has cooled down.
- Page 12 LED Light is Flashing Problem Cause Solution Count the blinking light sequence between each pause. If this chart applies to your • • The water tank Wait about one minute. BB-2000, you may need some replacement parts. Please contact our support team Water does is not filled.
- Page 13 Specifications BB-2000 WARRANTY SUMMARY Power Rating 120Vac, 60Hz, 1400W 3 Year Full Warranty Water Inlet Pressure 0.04 ~ 0.74MPa (0.4 ~ 7.5 kgf/cm) At-Home Repair Instructions (Limited to certain products) Power Cord 4 feet Service Center Repair Option* *Warranty does not cover inbound shipping. Rear Wash Max.
- Page 14 Notes This warranty does not apply to the following items: • Damage or loss sustained in a natural calamity such as fire, earthquake, flood, thunder electrical storm, etc. • Damage or loss resulting from any unreasonable use, misuse, abuse, negligence, or improper maintenance of the product. •...
- Page 15 Customer Support T: 847.458.2334 TOLL-FREE: 877.339.5214 7900 S IL Route 31 Crystal Lake, IL 60014 support@biobidet.com www.biobidet.com...
Need help?
Do you have a question about the bioBidet BLISS BB-2000 and is the answer not in the manual?
Questions and answers
I do not understand how to adjust the nozzle to clean for feminine or rear, we just installed it and the water hits behind me and gets my tailbone and shirt wet rather than coming farther forward.