Rheem TRITON GHE80SS Service Training Manual page 55

DISASSEMBLY AND REPAIR
Igniter
1. Disconnect power to the water heater.
2. Remove the green grounding wire.
3. Remove the two Phillips screws.
4. Remove the igniter assembly. You may need a small putty
knife to get it started.
5. Clean all old gasket material from burner assembly.
6. Replace igniter in reverse order.
Flame Sensor
1. Disconnect power to the water heater.
2. Disconnect cable from control board.
3. Remove the two Phillips screws.
4. Remove the flame rod. You may need a small putty knife
to get it started.
5. Clean all old gasket material from the burner assembly.
6. Replace in reverse order.
55
Pressure Switches
1. Disconnect power to the water
heater.
2. Remove all wiring connections
and rubber tubing to the pres-
sure switch.
3. Remove the Phillips screw hold-
ing the pressure switch assem-
bly in place.
4. Replace in reverse order.
Exhaust Gas Temperature Sensor
1. Disconnect power to the
water heater.
2. Remove the white wires from
the exhaust gas sensor.
3. Remove the sensor using a
wrench.
4. Replace in reverse order.
Rheem TRITON TM
Service Manual