Stuttering - Numark CDN34 User Manual

1 2 . C U E - Pressing the "CUE" button returns the CD to the last
set "CUE" point and pauses it. The "CUE" point is either the
position at which "PLAY" was last actually started or the
"LOOP IN" point if one was previously set. Pressing the
"CUE" button a second time allows the music to be played
from the "CUE" position until it is released. Repeatedly
pressing the "CUE" button allows the CD to be played from
the same position any number of times. The CUE LED will
light up from the time the CUE button is pressed until the CD
has reset to the position at which play was started. Steady
lighting of this LED indicates the ready condition.
1 3 . S T A R T / P A U S E ( P l a y / P a u s e B u t t o n ) - Each press of
the Play/Pause Button causes the operation to change from
play to pause or from pause to play.
1 4 . P I T C H S L I D E R - The pitch can be changed up to +/-12%
by pressing the "PITCH" button so the PITCH LED is lit, then
moving the sliding fader. The pitch will not be changed if the
PITCH LED is off.
15. COUNTER BUTTON - Tap this button with the beat of the
music to determine the current Beats Per Minute (BPM).
16. BPM BUTTON - Switches the mode of the display
between showing the BPM and the percentage change in
pitch.
17. LOOP IN BUTTON - Used for setting a start loop point
and new cue points during play
17. LOOP OUT BUTTON - Used for setting the end loop
point and releasing the loop action
18. RELOOP/STUTTER BUTTON- Depending on mode this
button is used for either repeating a previously set loop or
seamlessly stuttering on a the last set cue point.
©1999
Industries
T R A N S P O R T F E A T U R E S
19. DISC TRAY - Place your CD in here.
20. OPEN/CLOSE (Disc Tray Open/Close) - Press to
load or eject the disc. Each press will open or close the disc
tray on the transport. NOTE: Tray will not open unless the
disc has been paused.
21. POWER BUTTON - Turn on and turn off the machine from
this button. The unit should always be shut down with this
button first before any external power is removed.
22. RCA AUDIO JACKS - Connect your CD player to your
mixer from this line level output.
23. VOLTAGE SELECTOR - Set this switch to the voltage for
your location.
24. IEC POWER CONNECTOR - Plug your supplied power
cord into here then plug unit into a power outlet.
25. CONTROL CONNECTOR - Plug your control cables for
each unit into here and the back of the remote unit.
26. DIGITAL OUTPUTS - The format is type 2, form 1, also
known as S/PDIF (Sony/Phillips Digital Interface Format).
In order to use the digital output you must be
sure not to vary the pitch in any way. To en
this, press the pitch button to deactivate the variable pitch
slider and don't use the pitch bend buttons or pitch wheel. If
you adjust the pitch, other devices will not read the digital
output properly. Also do not use the stuttering or
loop buttons during digital output otherwise external units
may not receive the signal properly.
230V
115V
- The Leader in DJ Technology
9
CDN-34
sure
26
http://www.numark.com