Numark CDN34 User Manual page 15

PLAYING YOUR LOOP
To return to the beginning of the song and play after you are happy with the loop:
a. Press "PAUSE" to stop the play action of the CD or "CUE" to return to the "LOOP IN" point
b. Track backwards until you reach the beginning of the song.
numbers for the same song.)
c. Auto-cue to the beginning of the track will then occur. Once this occurs your cue button will return you
to this point until you pass over the "LOOP IN" point. Then "LOOP IN" will be the new "CUE" point.
d. The "LOOP OUT" LED will be flashing indicating a preset loop is ahead and will be played when reached
e. When the "LOOP IN" point is reached both "LOOP IN" and "LOOP OUT" LEDs should flash
f. The LOOP should occur as preset by you until you release it with the "LOOP OUT" button
g. Both "LOOP IN" and "LOOP OUT" LEDs should then go solid again indicating the possibility of
RELOOP
N O T E : If you should decide that you do not want to automatically play a preset loop after you start
a song, just press "LOOP OUT" anytime before you actually reach the "LOOP OUT" point and the
"LOOP OUT" LED will remain solid. (You can press it again before the "LOOP IN" point if you
change you mind.) The "LOOP IN" LED will come on solid when this point is reached indicating the
possibility of RELOOP. This will allow you to use the selection for reloop purposes. However, until
you pass the "LOOP OUT" point the "RELOOP/STUTTER" button only acts as a STUTTER
function as explained in STUTTERING FFFUN.
If you turned off your "LOOP OUT" while practicing your loop remember to turn it on again before reaching the
"LOOP IN" point.
ERASING YOUR LOOP
To erase a preset loop either;
a. Open and close the door
b. Press the program button twice
c. Select a track, a new "CUE" point, or new "LOOP IN" point beyond the "LOOP OUT" point
d. Press "LOOP IN" prior to the old point to set a new loop
DESCRIPTION OF LED DISPLAYS
1) LOOP IN on /LOOP OUT off : This
means that there is a LOOP IN point available
for looping and stuttering, but no LOOP OUT
point is set yet.
2) LOOP IN flashing /LOOP OUT
flashing: This indicates that the CD player is
actively looping from LOOP IN to LOOP OUT.
3) LOOP IN on /LOOP OUT on : This
indicates that the LOOP IN and LOOP OUT
points are set and a RELOOP will return to the
LOOP IN to play the loop.
©1999
Industries
4) LOOP IN off /LOOP OUT off : This indicates that
a) there is a LOOP IN point stored into memory, but this
looping function and this STUTTER point are
disabled until the music plays through the point.
b) there is no LOOP OUT point set yet.
5) LOOP IN off /LOOP OUT on : A future loop has been
stored into memory. This loop will be inactive until either LOOP
OUT is presses prior to the CD playing through the LOOP IN
point or RELOOP is pressed after the LOOP IN point.
6) LOOP IN off /LOOP OUT flashing : An active loop is
stored into memory and will automatically play after the music
plays through the LOOP IN point.
- The Leader in DJ Technology
15
(Remix CD's often contain multiple track
http://www.numark.com
CDN-34