Preparation; Battery Replacement For The Remote Control - JVC UX-D100 Instruction Manual

Preparation

Battery Replacement for the Remote Control

1. Press and hold the
control to open the back cover.
2. Insert two AAA size batteries. Make sure the (+) and (–)
ends indicated in the battery compartment.
3. Replace the back cover.
Ensure the back cover is correctly positioned. Incorrect
installation will damage the remote control.
Handling the Battery
• Improper or incorrect use of batteries may cause corrosion or battery leakage, which could
cause fire, personal injury or damage to property.
• Only use the battery type indicated in this manual.
• Do not install new batteries with used ones and do not mix different types of batteries.
• Do not dispose of used batteries as domestic waste. Dispose of them in accordance with
local regulations.
• Do not expose the batteries to excessive heat such as sunshine, fire or the like.
Handling the Remote Control
• Do not drop the remote control.
• Do not allow anything to impact the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
• Do not place the remote control under direct sunlight or near sources of excessive heat.
• Remove the battery from the remote control when not in use for a long period of time, as corrosion or
battery leakage may occur and result in physical injury, and/or property damage, and/or fire.
• When the battery is exhausted, the remote control will not function.
UX-D100_IB.indd 9
button at the back of the remote
9
21/04/2015 10:29