Getting Started; Connection And Preparation; General Device Functions - JVC RA-E981B Instruction Manual

To install the batteries
Lift off the battery compartment cover from the rear of the remote control. Insert 2 x 1,5V AAA
size batteries in accordance with the diagram in the battery compartment. Take care to observe
the correct polarity.
Remote control operation
To operate the unit with the remote control, point the remote handset at the remote sensor on
the front panel and press the appropriate button on the remote handset.
The remote works best within a range of 6 ~ 7 meters from the front panel and on an angle of
30 degrees. Bright sunlight or room light conditions can interfere with the remote control. If the
remote operation is unsatisfactory or stops working entirely, first try replacing the remote
batteries, then try reducing the room lighting conditions.

GETTING STARTED

CONNECTION AND PREPARATION

Connect the power adaptor to the back of device and plug it into power socket. Switch on the
device, it starts up.
Pull out the rod DAB/FM antenna for DAB and FM reception.
Connecting to the network
• A broadband connection in combination with a wireless access point, router or similar
network device.
• The network device needs to support WiFi (802.11 b/g/n) wireless connection. Make sure
you have setup the wireless network and you have the WEP, WPA or WPA2 security
password to activate the connection. You may also use the WPS (WiFi Protected Setup)
function for easy pairing between the network device and JVC RA-E981B. Check if the light
indicators on the network device are in appropriate status.
Connecting the line out
Use a standard audio cable to connect from the line out socket on the back of the device to the
external device.
Connecting the headphones
Turn the volume down before using the headphones. Inset the headphone plug (standard 3,5
mm) into the headphone socket at the front of the device.

GENERAL DEVICE FUNCTIONS

Power on/off
Press and hold /MODE on the device or press
mode. The time, date and any active alarm times display on the screen. Switch on with the
same button.
Mode selection
/MODE on the device or MODE on the remote control to select modes. Rotate the
Press
knob or press /
Menu operation
Press and hold MENU/INFO on the device or MENU on the remote control to open the menu.
Press again to close the menu and return to playing screen. On the menu, rotate the knob or
on the remote control to move along the entries. Press OK to confirm. Press BACK
press /
on the device or on the remote control to step back.
on the remote control to select mode. Press OK to confirm.
on the remote control to switch to standby
EN