Definitive Technology DYMENSION DM10 User Manual page 30

Bi-amping | Variable bi-polar
Remove both jumper cables. Connect negative speaker wires from the negative am-
plifier binding post to the negative
Connect the positive speaker wire to the positive (red) rear (0db) and speaker input
binding posts. Connect a pair of interconnect cables between the first amplifier or
AVR pre-outs and the second amplifier or AVR amp-in inputs. Be sure to connect posi-
tive red binding posts to positive binding posts and negative to negative.
Note: To adjust the level of the rear array, use the volume controls on the second
amplifier or AVR. If that is not available, connect an attenuator between the first and
second amplifier or AVR.
Audio Input
Preamp Out
Rear
Amplifier 2
Speaker Out
Amplifier 1
Speaker Out
Speaker Input
and
30
binding posts. Similarly,