Toshiba MMU-UP0071MH-UL Service Manual page 72

<Line (system) address>
5
Push [ ] to black highlight the code (DN), and then push [
number to 12.
6
Push [ ] to black highlight the data, and then push [
address.
(Match the address with the address on the interface P.C. board of the header outdoor unit in the same
refrigerant line.)
7
After finishing setting the data of the code (DN), push [
→ "Continue?" is displayed.
<Indoor unit address>
8
To set the data of Indoor unit address, push [
9
Push [ ] to black highlight the code (DN), and then push [
number to 13.
10
Push [ ] to black highlight the data, and then push [
address.
11
After finishing setting the data of the code (DN), push [
→ "Continue?" is displayed.
<Group address>
12
To set the data of Indoor unit address, push [
13
Push [ ] to black highlight the code (DN), and then push [
code number to 14.
14
Push [ ] to black highlight the data, and then push [
address.
If the indoor unit is individual, set the address to 0000 ; header unit, 0001 ; follower unit,
0002.
Individual : 0000
Header unit : 0001
Follower unit : 0002
15
After finishing setting the data of the code.
(DN), push [
→ "Continue?" is displayed.
16
To not do other settings, push [
→ If the "Indoor unit" or "Outdoor unit" selection screen is displayed before "
[ Return].
→ " "appears while data is changing.
→ The changes are fixed, and the "Field setting menu" screen returns.
}
In case of group control
Set/Fix].
Set/Fix].
Set/Fix].
Return].
– 72 –
] and [ ] to set the code
] and [ ] to set a system
Set/Fix].
] and [ ] to set the code
] and [ ] to set a Indoor unit
Set/Fix].
] and [ ] to set the
] and [ ] to set a group
" is displayed, push