Operation - Westinghouse ePX3100V User Manual

Electric pressure washer 2100 psi | 1.76 gpm
Hide thumbs Also See for ePX3100V:
Table of Contents

Advertisement

Available languages

Available languages

OPERATION

WARNING
product unless instructed to so in this manual or
by the manufacturer. Do not use attachments or
accessories that are not recommended for use with
this product. Making unauthorized modifications
and using incompatible accessories can damage
the unit and may void your warranty.
WARNING
to prevent injury to eyes when operating the pressure
washer.
WARNING
person, animal, electrical device, or the unit itself.
Failure to heed this warning could result in serious
injury, electric shock, or death.
STARTING AND STOPPING THE
PRESSURE WASHER
See Figure 8.
l Connect a garden hose as described previously and
turn the water on.
NOTICE
"ON " before turning the pressure washer power
to "ON". Running the pump dry of water will cause
damage to the internal components and render the
pressure washer inoperable.
l Connect a garden hose and turn the water on.
l Put the on/off switch in the OFF position (O).
l Completely unwind the power cord and connect it to a
grounded 120 volt outlet.
WARNING
off the ground. Do not touch the plug with wet
hands.
l Hold the spray gun with both hands and point the lance
in a safe direction.
12 | English
Do not alter or modify this
ALWAYS wear eye protection
NEVER spray directly at a
ALWAYS turn the water supply
Keep all connections dry and
l Release the safety lock and squeeze the trigger
to release water and air out of the hose. Continue
squeezing the trigger until there is a steady stream of
water, then release and lock the trigger. Refer to Using
the Spray Gun later in this section.
l Put the on/off button in the ON position (I) to start the
pressure washer. The unit will run for several seconds
and shut off. This is a normal function of the auto-start
feature.
NOTE: The unit could be pressurized even if you don't
hear the motor and pump running. Always be cautious
when you are around a pressure washer.
l Put the on/off switch in the OFF position (O) to stop the
pressure washer.
l When you stop the pressure washer, water pressure
may remain in the system. Point the spray gun in a
safe direction and pull the trigger to release the water
pressure.
FIG. 8
A - On/Off Button
A

Advertisement

Table of Contents
loading

Table of Contents