Westinghouse ePX3100V User Manual page 13

OPERATION
USING THE SPRAY GUN
See Figure 9.
WARNING
with two hands (one hand to pull the trigger and the
other to stabilize the gun) until you get used to the
"recoil". Do not lose control of the spray gun doing
so could result in injury to yourself and others.
l Start the pressure washer.
l Release the safety lock by pushing it down into the slot
in the trigger.
l Squeeze and hold the trigger to start the flow of water.
l Release the trigger to stop the flow of water.
l Lock the trigger by pushing it up to its original position.
NOTE: Squeeze the trigger to make sure its locked
and will not move. ALWAYS keep the spray gun locked
when it's not in use.
INSTALLING NOZZLES
See Figure 10.
WARNING
washer, release the pressure in the spray gun,
and lock the trigger before removing or installing a
nozzle. NEVER point the lance at your face. Failure
to heed this warning could result in serious injury.
l Stop the pressure washer and turn the water faucet
completely off.
l Point the spray gun in a safe direction and pull the
trigger to release the water pressure.
l Lock the trigger.
l Push the nozzle into the lance until it clicks into place
and is secure.
l To remove the nozzle, pull the collar back and move the
nozzle away from the lance.
NOZZLE
High Pressure. Use to clean con-
crete, remove tough stains, and
Turbo
strip paint. Use with caution.
15°
Moderate pressure. Safe to use
on brick and paved patios.
25°
FOAM
CANNON
Low Pressure. Safe for cars, win-
dows and decks.
Hold the spray gun and lance
ALWAYS turn off the pressure
GENERAL USE
GENERAL USE
CLEANING WITH THE PRESSURE
WASHER
See Figures 11 - 13.
To clean with detergent:
l Stop the pressure washer and turn the water faucet
completely off.
l Point the spray gun in a safe direction and pull the
trigger to release the water pressure.
FIG. 9
A - Trigger
B - Safety Lock
FIG. 10
B
E
A - Nozzle
B - Lance
C - Collar
D - Push Nozzle In
E - Pull Collar Back
F - Remove Nozzle
B
C
F
English | 13
A
A
D