Working - Festool CT 15 E HEPA Original Instructions Manual

LED lights up Excessive temperature
red
LED flashes Electrical outlet module cir­
red cuit breaker has tripped
► Switch off the mobile dust extractor, let it
cool down.
► Switch on the mobile dust extractor again
after approx. five minutes.
If the thermal circuit breaker in the electrical
outlet module is triggered by an overload, it can
be reset by switching the mobile dust extrac­
tor [1-10] off and on again.
If the mobile dust extractor still cannot be
switched on after resetting the circuit
breaker: Contact a Festool service work­
shop.
8

Working

8.1 Dust extraction
Extracting dry materials
Always use a filter bag.
8.2 Extracting wet materials/liquids
Remove the filter bag!
Use a special wet filter.
The dust extraction stops automatically when
the maximum fill level is reached.
The bottom LED [1-12] lights up red.
► Switch off the mobile dust extractor [1-10].
► Open the locking clips [1-7] and remove the
top section of the machine.
► Empty the dirt trap [1-9].
After wet extraction, allow the main filter to dry!
Dry the mobile dust extractor before extracting
dry dust.
CAUTION
Hazardous dust
Damage to the respiratory passage
► After extracting wet materials, remove the
wet filter and replace it with the main filter
for dry materials.
CAUTION
Escaping foam and liquids
► Switch off and empty the machine immedi­
ately.
8.3 Exhaust-air outlet
CAUTION
Hazardous dust
Damage to the respiratory passage
► Do not blow off any dust!
The exhaust-air outlet offers the option of di­
verting the exhaust air outside a building using
the suction hose.
► Open the grille in front of the exhaust open­
ing [1-8].
► Insert the suction hose in the exhaust open­
ing [1-8].
8.4 Changing the filter bag with minimal
dust
► Open the locking clips and remove the top
section of the machine [2].
► Pull the tab on the filter bag until the filter
bag opening is fully closed.
The filter bag is now securely closed and can be
removed.
► Fit the top section of the machine and close
the locking clips.
8.5 Changing the filter element [6]
► Pull out the used filter drawer [1-6].
► Dispose of the used filter drawer in accord­
ance with statutory regulations.
► Insert the new filter drawer [1-6].
Order numbers for accessories, filters and
consumables in the Festool catalogue or
online at "www.festool.com".
– Only use original Festool accessories and
consumables. Only accessories tested and
approved by Festool are safe and perfectly
adapted to the machine and application.
NOTICE
Damage to the motor
► Never extract material without a main filter
or with a damaged main filter, as this can
damage the motor.
8.6 After finishing work
► Switch off the mobile dust extractor and
pull out the mains plug.
► Vacuum and wipe the inside and outside of
the mobile dust extractor to clean it.
► Empty the dirt trap.
► Wind up the mains power cable.
English
9