Approvals; Revision - Abloy DB001 Installation Manual

APPROVALS / STANDARDS
Low Voltage directive 73/23/EEC as amended by the directive 93/68/EEC
EMC directive 89/336/EEC as amended by the directice 92/31/EEC and 93/68/EEC
The DB swing door operator complies with the door weights/widths stated in the:
Controlled door closing, EN 1154 size 3-6
Electrically powered hold-open device for swing doors, EN 1155
Coordination unit for rebated doors, EN 1158

REVISION

Following pages has been revised 25.1.2010:
Page Revision
33 Capacitor 100µF / 50V added to the connection picture.
------------------- THIS MANUAL CONTAINS IMPORTANT SAFETY INSTRUCTIONS -------------------
Warning - IT IS IMPORTANT FOR SAFETY OF PERSONS TO FOLLOW THESE INSTRUCTIONS.
-------------------------------------------- SAVE THESE INSTRUCTIONS --------------------------------------------
Do not allow children to play with fixed controls.
Frequently examine the installation for imbalance and signs of wear or damage to cables, springs and
mountings. Do not use if repair or adjustment is necessary.
Disconnect the supply when cleaning or other maintenance is being carried out.
Before installing the operator, check that the door is in good mechanical condition and it opens and
closes properly.
Ensure that entrapment between door and the surroundings is avoided.
Ensure that the operator is suited for installation. Check temperature, humidity, door weights, etc.
restriction, what is mentioned in this manual or other Abloy
Note!
Instructions, design specifications and illustrations which are contained in this manual are not binding.
Rights reserved for changes without previous notice.
2
Warning! Warning!
Oy material.
®