Echo shindaiwa DCS-1600 Service Manual page 37

DCS-1600
5-2 Installing switches and trigger lever (Continued)
F
E
C
G
F
SWITCH AND TRIGGER
d
J
X
Y
X
6. Install trigger lever (C) on motor cover while
placing the end (d) of torsion spring on motor cover
as shown.
NOTE: Check the position of trigger lever (C) and
torsion spring (D).
C
D
7. Install lockout button (E) on motor cover as
shown.
8. Install compression spring (F) on lockout button
(E) as shown.
9. Pass lead (J) of wire harness between ribs of mo-
tor cover as shown.
10. Assemble motor cover halves.
NOTE: Be careful when assembling the covers:
- Do not to pinch each lead by the covers
- Do not to drop compression spring (F) off
- Do not to misplace weld nut (G)
11. Tighten six bolts (X) (size : M4x16mm length),
bolt (Y) (size : M4x20mm length) and three bolts (Z)
(size : M5x20mm length) to secure motor cover.
12. Reassemble removed parts.
- Worm gear and drum (Refer to Section 4-3)
- Brake lever and switch (Refer to Section 3-2)
Z
OK NO
C
D
35