Echo shindaiwa DCS-1600 Service Manual page 9

DCS-1600
2-2 Troubleshooting chart (Continued)
Troubleshooting "STEP1" ~Checking battery and charger~
Start
A
No
B
Yes
D
No
E
Yes
Step0
TROUBLESHOOTING
Step2
C
Yes
F
No
Yes
M
No
N
Yes
G
No
No
P
Yes
Q
No
H
Yes
R
J
No
K
Yes
L Step2
A: Press battery buttton
status.
B: Is LED indicator of battery lighting?
C: Go to "Step 2" to find cause of battery failure.
After passing Step2 then replace the battery to
new one and continue to diagnosis.
* Be sure to check Troubleshooting "Step2"
before installing new battery. If the unit has
something wrong, the battery can be damaged
again.
D: Charge the battery.
E: Is battery fully charged?
F: Does LED indicator of charger remain red?
G: Is LED indicator of charger flashing red?
H: Does LED indicator of charger light?
J: Prepare good battery and charger and then
cross-check.
K: Battery failure?
L: Go to "Step 2" to find cause of battery failure.
After passing Step2 then replace the battery to
new one and continue to diagnosis.
* Be sure to check Troubleshooting "Step2"
before installing new battery. If the unit has
something wrong, the battery can be damaged
again.
M: Is temperature of battery inside in the range of 5
to 40°C?
N: Cool or warm battery as needed.(Rechargeble
temperature of battery inside is 5 to 40°C.)
P: Are connectors of battery and charger dirty?
Q: Clean connectors of battery and charger.
R: Replace the charger with new one.
7
to indicate charging
*
*