Name And Priority; Trigger Settings - Bosch LHN-UC15L-SIP User Manual

32 en | Web-GUI configuration
4.7.1

Name and priority

Label Field
Use the Label field to enter a unique name for the rule.
Enabled check box
Use the Enabled check box to activate or deactivate a rule. You can also use the slider button
on the main Rules page to activate and deactivate a rule.
Priority field
Use the Priority field to define the importance of the rule. Enter the priority in the field or use
the + and - to increase or decrease the value.
The range for this field is 1 (lowest) to 100 (highest).
The rule with the highest priority will start if there are active triggers on both rules. If a rule
with a lower priority is already in effect, it is stopped.
4.7.2

Trigger settings

Trigger settings define the event that starts an action. You can initiate actions by a schedule,
by ambient noise, by an incoming SIP call, by a physical GPI, or by using a virtual GPI.
Schedule only
Use the Schedule only trigger type when an action is time-controlled. For example, an alarm
sounds at the same time every day. You can schedule actions to perform minutely, hourly,
daily, weekly, monthly, yearly. Select the option Always to bypass or take out the time-
controlled settings.
SIP
Use the SIP trigger type to configure an action to start when a call comes into the system. The
most common application of the SIP trigger type is using a SIP call (Action type - Route call).
Another possibility for the SIP trigger type is to initiate an action using DTMF (Dual Tone Multi-
Frequency).
You can combine this trigger type with a schedule via Schedule type, if applicable. Otherwise,
keep the default setting of Always.
There are two additional parameters needed when using the SIP trigger type:
–
–
GPI
Use the GPI trigger type to initiate an action via a physical GPI (General Purpose Input). The
device offers one physical GPI. For information on installing the GPI, see Installation, page 8 .
You can combine this trigger type with a schedule via Schedule type, if applicable. Otherwise,
keep the default setting of Always.
Configure the physical GPI on Maintenance, page 37 , using the GPI active range parameter.
VGPI (Virtual GPI)
Use the VGPI trigger type to initiate an action via a virtual GPI. The device offers 16 virtual
GPIs. You can manually configure these GPIs from the user interface via Maintenance, page
37 , under Virtual GPIs or by using the API.
You can combine this trigger type with a schedule via Schedule type, if applicable. Otherwise,
keep the default setting of Always.
2023.02 | V01 | F.01U.389.835
You must select the appropriate SIP account. For more information on SIP account
configuration, see the SIP page.
You must select the appropriate DTMF code, if applicable.
LHN‑UC15L‑SIP | LHN‑UC15W‑SIP | AMN‑P15‑SIP
User manual
Bosch Security Systems B.V.