Table of Contents
Advertisement
Instruction Manual
CVG101 Worker Bee
2.2 Safety Precautions - Service and operation
Ensure that the vacuum port on which the CVG101 vacuum gauge is mounted is electrically grounded.
Remove cable to the unit before attempting to service the gauge.
Remove cable to the the unit if a cable or plug is damaged or the product is not operating normally according to
this User Manual. Contact qualified InstruTech service personnel for any service or troubleshooting condition
that may not be covered by this User Manual.
It is important that the product be periodically inspected for sound electrical connections and equipment
grounding. Do not use if the equipment grounding or electrical insulation has been compromised.
Do not use if the unit has been dropped. Contact InstruTech for further instructions regarding evaluation of the
damaged sensor.
2.3 Electrical Conditions
WARNING! When high voltage is present in any vacuum system, a life threatening electrical shock hazard
may exist unless all exposed electrical conductors are maintained at earth ground potential. This applies to all
products that come in contact with the gas contained in vacuum chambers. An electrical discharge within a
gaseous environment may couple dangerous high voltage directly to any ungrounded conductor of electricity. A
person could be seriously injured or killed by coming in contact with an exposed, ungrounded electrical
conductor at high voltage potential. This condition applies to all products that may come in contact with the gas
inside the vacuum chamber (vacuum/pressure containment vessel).
2.3.1 Proper Equipment Grounding
WARNING! Hazardous voltages that could seriously injure or cause death are present in many vacuum
processes. Verify that the vacuum port on which the CVG101 vacuum gauge sensor is mounted is electrically
grounded. Consult a qualified Electrician if you are in doubt about your equipment grounding. Proper
grounding of your equipment is essential for safety as well as intended operation of the equipment. The
CVG101 vacuum gauge sensor must be connected directly to a good quality earth ground. Use a ground lug on
the CVG101 gauge vacuum connection / flange if necessary.
WARNING! In order to protect personnel from electric shock and bodily harm, shield all conductors
which are subject to potential high voltage electrical discharges in or around the vacuum system.
2.3.2 Electrical Interface and Control
It is the user's responsibility to ensure that the electrical signals from this product and any connections made to
external devices, for example, relays and solenoids, are used in a safe manner. Always double check the system
set-up before using any signals to automate your process. Perform a hazardous operation analysis of your
InstruTech, Inc.
Page 4
Advertisement
Table of Contents
