Advertisement
Maine Installation Guide (with underframe) - vJUN17
10 mm
20 mm
Fit one length of the vertical seal full height on the handle side of the door and trim
8
it level with the top edge of the glass.
The bottom end of the seal should extend down to the top of the underframe but
should be notched as shown so that it does not interfere with the horizontal seal which
will be fitted to the bottom of the Door.
The Majestic Shower Company Limited
17 Flitch Industrial Estate, Chelmsford Road, Dunmow, CM6 1XJ
Remove sharp corners
End to touch top of
underframe
Notch
12.5mm
The other length of vertical seal is to be cut in 3 sections to fit to the door above,
9
below and between the hinges.
For maximum resistance to leakage, the seal sections should be cut as shown
above to allow them to fill the gaps in the hinge through which water might
otherwise escape.
Telephone +44 (0) 8448 001 500
Facsimile +44 (0) 1279 635 074 info@majesticshowers.com www.majesticshowers.com
Slit
Slit bubble here
6
Advertisement
