List Of Procedures; List Of Tables - Northern Telecom Meridian Meridian 1 Installation Manual

Figure 21
Figure 22
Figure 23
Figure 24
Figure 25
Figure 26
Figure 27
Figure 28
Figure 29

List of procedures

Procedure 1
Procedure 2
Procedure 3
Procedure 4
Procedure 5
Procedure 6
Procedure 7
Procedure 8
Procedure 9
Procedure 10
Procedure 11
Procedure 12

List of tables

Table 1
Table 2
Table 3
Table 4
Table 5
Table 6
Module-to-module power and system monitor
connections 44
Module mounting bolts 45
Module positioning guides 45
Module power harness power connector 48
System monitor cable at connector J2 48
Removing the air exhaust grill 49
Cable well for wiring 50
Alignment tab on connector 51
Top cap assembly 52
Power connections (ac) 9
Power connections (dc) 15
Alarm connections 22
ST system with QCA136 cabinet connections 26
ST system with QCA137 cabinet connections 28
RT system with QCA147 cabinet connections 31
ST system with QCA147 and QCA137 cabinet
connections 33
RT system with QCA147 and two QCA137
cabinet connections 36
NT or XT system with QPC84 or QPC173 cabinet
connections 39
Adding an AEM to the base of a column 46
Adding an AEM between two other modules 47
Add an AEM to the top of a column 48
Pedestal wire gauge requirements with two
30-amp 48 V dc feeds (see Note 1) 14
NT8D22 switch settings (set as slave) for
operation with Meridian 1 22
SW2 positions 3 - 8-unit number for the slave
24
ST/RT alarm connection hardware requirements
25
NT8D22 switch settings (set as master) for
operation with ST 26
NT8D22 switch settings (set as master) for
operation with ST 28
Application Equipment Module Installation guide
Contents iii