Specifications; Maintenance - DeWalt DCF512 Instruction Manual

1. Install appropriate accessory onto the anvil
2. Place the accessory on the fastener head. Keep the tool
pointed straight at the fastener.
3. Consider the intended operation and select either
forward or reverse rotation.
4. Press variable speed trigger switch
5. Release variable speed trigger switch
6. If the ratchet stalls, the tool is overloaded or is being
improperly used. Release the variable speed trigger
switch 1 immediately. Do not press the variable speed
trigger switch 1 on and off in an attempt to start a
stalled ratchet. Doing so can damage the tool.
7. The ratchet can also be used manually for starting
stubborn fasteners or snugging by releasing the trigger
and applying the torque by hand.
NoTE: Excessive manually applied torque may damage
the tool housing or mechanism.

MAINTENANCE


WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start‑up can cause injury.
Your D WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the
risk of eye injury, always wear approved eye protection
when performing this procedure.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non‑metallic parts of the
tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
Accessories

WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center.
Repairs
The charger and battery pack are not serviceable.

WARNING: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (including brush
inspection and replacement) should be performed by a
D WALT factory service center or a D
e
service center. Always use identical replacement parts.
2 .
1 to start operation.
1 to stop operation.
WALT‑recommended
e
WALT‑authorized
e

SPECIFICATIONS

DCF512
Volts
Anvil
Torque Max
Breakaway Torque
Speed
LED
ENglish
20 V Max*
1/2"
75 ft‑lbs (102 Nm)
75 ft‑lbs (102 Nm)
250 RPM
Yes
25