Steps
1. Using the pull tab, disconnect the battery cable from the connector on the system board.
2. Remove the four screws (M2x3) that secure the 4-cell battery to the palm-rest and keyboard assembly.
3. Lift the 4-cell battery, along with the battery cable, off the palm-rest and keyboard assembly.
4. Carefully push and remove the battery rubber stopper out of the bottom-left screw hole of the 4-cell battery.
NOTE:
When replacing the 4-cell battery, use a plastic scribe to push upward through the bottom-left screw hole to
remove the battery rubber stopper and transfer it to the new replacement 4-cell battery.
Installing the 4-cell battery
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the 4-cell battery and provides a visual representation of the installation procedure.
Removing and installing Field Replaceable Units (FRUs)
53