Steps
1. Place the system board thermal plate in the slot on the system board.
2. Align the screw holes on the system board thermal plate to the screw holes on the system board.
3. Tighten the four captive screws to secure the system board thermal plate to the system board.
NOTE:
Tighten the four captive screws in the sequential order mentioned on the system board thermal plate [1 > 2 > 3
> 4].
4. Replace the two screws (M2x5) to secure the system board thermal plate to the palm-rest and keyboard assembly.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Touchpad
Removing the touchpad
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
3-cell battery
About this task
The following images indicate the location of the touchpad and provide a visual representation of the removal procedure.
After working inside your
Before working inside your
or the
4-cell
battery, whichever applicable.
computer.
computer.
Removing and installing Field Replaceable Units (FRUs)
61