Advertisement
QIG-TMX4P-492SVS
UN492S-TMX4P, UN492VS-TMX4P
Note that LAN power is OFF out of the box so this will need to be changed for each display
within the wall.
7.
Go into the Multi-DSP menu of the display 1 which will be where you first started the LAN
daisy chain and enable the AUTO ID within the ID Control setting. This will automatically
set a monitor ID to each display along the LAN daisy chain. Note that the displays will
automatically identify each screen consecutively depending on how you LAN daisy chained
the units.
If the control setup is as pictured below, each display does not need a unique IP address
assigned to still control each individual monitor.
Note that a unique IP address is not necessary to communicate to all displays if display 1 is
not connected to a network. The displays will automatically assign themselves IP
NEC Display Solutions of America, Inc.
Rev 1.1
4
Advertisement
