Foxconn 848P7MB Manual page 18

Front Panel Connector: FP1
This motherboard includes one connector
for connecting the front panel switch and
LED indicators.
IDE LED Connector (HD-LED)
The connector connects to the case's IDE indicator LED indicating the activity
status of hard disks.
Reset Switch (RESET)
Attach the connector to the Reset switch on the front panel of the case; the
system will restart when the switch is pressed.
Power LED Connector (PWRLED)
Attach the connector to the power LED on the front panel of the case. The Power
LED indicates the system's status. When the system is in S0 status, the LED is
on. When the system is in S1 status, the LED is blink; When the system is in S3,
S4, S5 status, the LED is off.
Power Swith Connector (PWRSW)
Attach the connector to the power button of the case. Pushing this switch allows
the system to be turned on and off rather than using the power supply button.
IrDA Header: IR
This connector supports wireless transmit-
ting and receiving device. Before using this
function, configure the settings of IR Mode
from the "Integrated Peripherals" section of
the CMOS Setup.
Chapter 2
848P7MB Series User Manual
Installation Instructions
P W R L E D P W R S W
+ -
2
1
+ -
HD-LED R E S E T NC
FP1
+5V
1
Empty
RX
GND
TX
IR
13