Controls; Engine Shut-Off Cord (Lanyard); Engine Oil - Yamaha F150D Owner's Manual

Operation
EMU37323
Checking the fuel filter
Check that the fuel filter is clean and free of
water. If any water is found in the fuel, or if a
significant amount of debris is found, the fuel
tank should be checked and cleaned by a
Yamaha dealer.
EMU36463

Controls

 Turn the steering wheel full-right and full-
left. Make sure operation is smooth and un-
restricted throughout the whole range with
no binding or excessive free play.
 Operate the throttle levers several times to
make sure there is no hesitation in their
travel. Operation should be smooth over
the complete range of motion, and each le-
ver should return completely to the idle po-
sition.
 Look for loose or damaged connections of
the throttle and shift cables.
EMU36484

Engine shut-off cord (lanyard)

Inspect the engine shut-off cord and clip for
damage, such as cuts, breaks, and wear.
46
1. Clip
2. Engine shut-off cord (lanyard)
EMU37054

Engine oil

1. Put the outboard motor in an upright po-
sition (not tilted). NOTICE: If the motor
is not level, the oil level indicated on
ZMU05493
the dipstick may not be accurate.
[ECM01791]
2. Remove oil dipstick and wipe it clean.
3. Insert the dipstick and remove it again.
Be sure to completely insert the dipstick
into the dipstick guide, otherwise the oil
level measurement will be incorrect.
4. Check the oil level using the dipstick to
be sure the level falls between the upper
level mark and lower level mark. Consult
your Yamaha dealer if the oil level is out
of specified level or if it appears milky or
dirty.
1. Oil dipstick
1
2
ZMU06873
1
ZMU06221