BRAKE
ADJUSTMENT
12.1 ADJUSTING THE BRAKES
AO
AQ
12.2 ADJUSTING THE CLUTCH
AS
AT
AP
AR
12.1.1 Front brake
The front brake is a hydraulically operated disc model and
hence does not require any adjustment. If you wish to adjust
the position of the lever, use adjuster AO.
Make sure you keep at least 5 mm of play on the lever.
12.1.2 Rear brake
The rear brake is a hydraulically operated disc model.
You can adjust the height of the pedal by turning the adjusters
AP and AQ.
Make sure you keep at least 5 mm of play on the pedal lever.
The only operation you can perform on the clutch is to adjust
the position of the lever AR.
You can perform this adjustment by turning the adjuster AS.
If you are making adjustments with the adjuster screw,
it is important, once you have finished, to make sure you
tighten up the lock nut AT so as to lock the adjuster screw in
the desired position.
NOTE: The clutch must have between 0.4 mm and 0.6 mm of play.
38
38
WORKSHOP MANUAL
TL 250
CHAPTER 12