Table of Contents
Advertisement
Laundry does not dry
properly or is still too damp.
Drying time too long.
Odor build-up in the device
Humidity in the room increases.
Unfamiliar noises when
drying.
The device feels cold despite
drying.
At the end of the program, warm laundry feels more humid than it
■
actually is. Spread out the laundry and let it cool down. Adjust the
dryness level or increase the level of dryness. This extends the drying
■
time while maintaining the same temperature.
Select the time program for drying laundry that is still
■
damp. Select the time program for a small load.
■
Maximum load of a program is not
■
exceed. ~ Page 21
Clean the moisture sensor in the drum. A fine layer of lime or
■
residues from detergents and care products can be
deposited on the sensor and its function
affect. ~ Page 41
Drying was interrupted by a power failure, a full
■
condensation container or by exceeding the maximum
drying time.
Also note the tips on washing. ~ Page 25
A notice:
The appliance can be soiled with lint. This causes a
■
longer drying time.
-
Clean the base unit. ~ Page 38
-
Complete drying with laundry that has not been
pre-dried and a load of more than 3 kg.
A notice:
The machine's automatic self-cleaning system uses
condensation from your laundry. If you permanently dry
loads of less than 3 kg, the condensation water in your
laundry will not be sufficient for the appliance to
automatically clean itself. Regularly dry laundry that has not
been pre-dried with a load of more than 3 kg.
The heat exchanger can be contaminated with lint.
■
- Carry out simple device care. ~ Page 43
A damp fluff filter can extend the drying time and
■
affect the drying result. Thoroughly dry the lint filter of
the floor unit after rinsing it. ~ Page 38
A blocked or not freely accessible air inlet on the device
■
can extend the drying time. Keep the air inlet free.
An ambient temperature lower than 15 ° C and higher
■
than 30 ° C can extend the drying time and affect the
drying result.
Insufficient air circulation in the room can increase the drying time.
■
Ventilate the room adequately.
Carry out intensive device care. ~ Page 44
Ventilate the room sufficiently.
During the drying process, operational noises are produced by the pump
and the compressor. These do not indicate a malfunction of the device.
No mistake. The device with heat pump dries efficiently at low
temperatures.
Device help
de
49
Advertisement
Table of Contents
