Table of Contents
Advertisement
Prerequisites
•
Procedure steps
Step
1
2
3
Copyright © 2007, Nortel Networks
.
WARNING
Risk of eye injury by laser
Fiber optic equipment can emit laser or infrared light that can
injure your eyes. Never look into an optical fiber or connector port.
Always assume that fiber optic cables are connected to a light
source.
CAUTION
Risk of equipment damage
To prevent damage from electrostatic discharge, always wear an
antistatic wrist strap connected to an ESD jack.
CAUTION
Risk of equipment damage
Only trained personnel can install this product.
Verify that the XFP is the correct model for your network configuration.
Action
Remove the XFP from its protective packaging.
Grasp the XFP between your thumb and forefinger.
Insert the XFP into the XFP slot on the module.
Apply a light pressure to the XFP until the device clicks and locks
into position in the module.
CAUTION
Risk of equipment damage
XFPs are keyed to prevent incorrect insertion. If the XFP
resists pressure, do not force it; turn it over, and reinsert it.
Ethernet Routing Switch 4500 Series
Installation — SFPs and XFPs
NN47205-301 (324186-A) 01.04 Standard
5.1 6 December 2007
Installing an XFP 29
Advertisement
Table of Contents
