Table of Contents
Advertisement
Technical specifications
Table 1. Ethernet Routing Switch 3510-24T technical specifications
Physical specifications
Weight: 3.2 kg (7 lb)
Height: 4.45 cm (1.75 in)
Width: 43.82 cm (17.25 in)
Depth: 20.80 cm (8.19 in)
Performance specifications
• Switch fabric bandwidth 80 Gbps for the switch
• Frame forwarding rate 35.7 Mpps (million packets per second)
for 3510-24T
Port forwarding/filtering performance
• For 10 Mbps: 14,880 pps maximum (64-byte packets)
• For 100 Mbps: 148,810 pps maximum
• For 1000 Mbps: 1,488,100 pps maximum
• Address database size: 8,000 entries at line rate (8,000
entries without flooding)
• Addressing: 48-bit MAC address
• Frame length: 64 to 1518 bytes (IEEE 802.1Q Untagged)
• 64 to 1,522 bytes (IEEE 802.1Q Tagged)
• Jumbo frame support: Up to 9,216 bytes
• Multi-Link Trunks: Six trunks, four members per trunk
• VLANs: 256 port-based or protocol-based VLANs Tagging
option
• Multiple Spanning Tree Groups: Up to eight STGs
Interface options
• 10BASE-T/100BASE-TX/RJ-45 (8-pin modular) connectors for
Auto MDI/MDI-X interface
• 1000BASE-T with auto-polarity
The Ethernet Routing Switch 3510 supports the following
SFP GBICs:
• 1000BASE-SX uses short wavelength 850 nm MTRJ or LC type
fiber optic connectors to connect devices over multimode
(275m, 62.5um core or 350m, 50.0um core) fiber optic cable
• 1000BASE-LX uses long wavelength 1300nm duplex LC type
fiber optic connector to connect devices over single mode
(10km, 9um core) fiber optic cable
• 1000BASE-CWDM uses long wavelength 1470, 1490, 1510, 1530,
1350, 1570, 1590, 1610nm LC type fiber optic connector to
connect devices over single mode (40km, 9um core or 70km,
9um core) fiber optic cable
Network protocol and standards compatibility
• IEEE 802.3 10BASE-T (ISO/IEC 8802 3, Clause 14)
• IEEE 802.3u 100BASE-TX (ISO/IEC 8802-3, Clause 25)
• IEEE 802.3u Autonegotiation on Twisted Pair (ISO/IEC 8802-3,
Clause 28)
• IEEE 802.3x (Flow Control on the Gigabit Uplink port)
• IEEE 802.3z 1000BASE-SX and 1000BASE-LX
• IEEE 802.1d MAC Bridges (ISO/IEC 10038)
• IEEE 802.1p (Prioritizing)
• IEEE 802.1Q (VLAN Tagging)
• IEEE 802.1D Spanning Tree Protocol
• IEEE 802.3ad (manual/static)IEEE 802.3ad (LACP)
†
• IEEE 802.1s
†
• IEEE 802.1w
• IETF DiffServ
6
RFC support
RFC 1213 (MIB-II); RFC 1493 (Bridge MIB); RFC 1573 (IF-MIB); RFC
2863 (Interfaces Group MIB); RFC 2665 (Ethernet MIB); RFC
2737 (Entity MIBv2); RFC 2819 (RMON MIB); RFC 1757 (RMON);
RFC 1271 (RMON); RFC 1157 (SNMP); RFC 2570 (SNMPv3); RFC
2571 (SNMP Frameworks); RFC 2573 (SNMPv3 Applications); RFC
2574 (SNMPv3 USM); RFC 2575 (SNMPv3 VACM); RFC 2576
(SNMPv3); RFC 2572 (SNMP Message Processing) RFC 791 (IP);
RFC 792 (ICMP); RFC 793 (TCP); RFC 783 (TFTP); RFC 826
(ARP); RFC 768 (UDP); RFC 854 (TELNET); RFC951 (Bootp); RFC
2236 (IGMPv2); RFC 1112 (IGMPv1); RFC 1945 (HTTP v1.0); RFC
2138 (RADIUS); RFC 894 (IP over Ethernet); RFC 2674 (Q MIB);
RFC 1058/RFC 1723 (RIPv1/v2)†; RFC 2030 (SNTP [Simple NTP])
Electrical specifications
• Input voltage (AC version): 100-240 VAC (+/- 10%) @ 47 to 63 Hz
• Input power consumption: (AC version): 90 W max
• Input current (AC version): 0.8 A maximum
• Input voltage (rms): 100 to 240 VAC at 50 to 60 Hz
• Maximum thermal output: 310 BTU/hr
Environmental specifications
• Operating temperature: 0° to 45°C (32° to 113°F)
• Storage temperature: –25° to +70°C (-13° to 158°F)
• Operating humidity: 85% maximum relative humidity,
non-condensing
• Storage humidity: 95% maximum relative humidity,
non-condensing
• Operating altitude: Up to 3,024 m (10,000 ft.) above sea level
• Storage altitude: Up to 3,024 m (10,000 ft.) above sea level
Mean time between failures (MTBF)
• 335,000 hours
Safety agency approvals
• UL60950
• CSA 22.2 No. 60950 (cUL)
• IEC 60950/EN 60950, CB report and certificate with all
national deviations
• UL-94-V1 flammability requirements for PC board
• NOM-019 (NOM)
Electromagnetic emissions summary
Meets the following standards:
• US: CFR47, Part 15, Subpart B, Class A
• Canada: ICES-003, Issue 3, Class A
• Australia/New Zealand: AS/NZS 3548:1995
• A1:1997/A2:1997 class A
• Japan: VCCI-V-3/02.04 class A
• Taiwan: CNS 13438, Class A
EN55022:1998/A1:2000
• EN61000-3-2:2000
• EN61000-3-3:1995/A1:2001
Electromagnetic immunity
• The module meets the EN55024:1998/A1:2000 standard.
†
Declaration of Conformity
As stated in the Declaration of Conformity, the Ethernet Routing
Switch 3510 complies with the provisions of Council Directives
89/336/EEC and 73/23/EEC.
†
Future software release
Advertisement
Table of Contents
