Storing The Tyre Sealant And Compressor Kit - Cadillac XT4 2023 Owner's Manual

7. Start the vehicle. The vehicle must be
running while using the air compressor.
8. Press the on/off button (5) to turn the
tyre sealant and compressor kit on.
The compressor will inflate the tyre with
air only.
9. Inflate the tyre to the recommended
inflation pressure using the pressure
gauge (8). The recommended inflation
pressure can be found on the Tyre and
Loading Information label. See Tyre
Pressure 0 288.
The pressure gauge (8) may read higher
than the actual tyre pressure while the
compressor is on. Turn the compressor
off to get an accurate pressure reading.
The compressor may be turned on/off
until the correct pressure is reached.
Caution
If the recommended pressure cannot be
reached after approximately 25 minutes,
the vehicle should not be driven farther.
The tyre is too severely damaged and the
tyre sealant and compressor kit cannot
inflate the tyre. Remove the power plug
Caution (Continued)
from the accessory power outlet and
unscrew the inflating hose from the tyre
valve.
10. Press the on/off button (5) to turn the
tyre sealant and compressor kit off.
Be careful while handling the compressor
as it could be warm after usage.
11. Unplug the power plug (9) from the
accessory power outlet in the vehicle.
12. Turn the air only hose (10) anticlockwise
to remove it from the tyre valve stem.
13. Replace the tyre valve stem cap.
14. Return the air only hose (10) and power
plug (9) back to their original storage
location.
15. Return the equipment to its original
storage location in the vehicle.
The tyre sealant and compressor kit has
accessory adapters in a compartment on the
bottom of its housing that can be used to
inflate air mattresses, balls, etc.
(Continued)
Vehicle Care
Storing the Tyre Sealant and
Compressor Kit
The tyre sealant and compressor kit is in a
bag in the rear compartment storage area.
1. Open the tailgate.
2. Remove the cargo cover, if equipped.
3. Lift the load floor. Use the hook to hold
the load floor open. See Rear Storage
0 79.
4. Turn the retainer nut anticlockwise to
remove the tyre sealant and compressor
kit bag.
5. Remove the tyre sealant and compressor
kit from the bag.
305