Table of Contents
Advertisement
7. To remove high voltage capacitor.
1) Remove the screw which secure the grounding ring
terminal of the H.V. diode and the capacitor holder.
2) Remove the H.V. diode from the capacitor holder.
3) Reverse the above steps for reassembly.
High voltage circuit wiring
8. To remove magnetron.
1) Pull out two terminals from the thermostat of
magnetron.
2) Remove a screw which secure the magnetron.
3) Remove the magnetron.
4) Remove the screws which secure the thermostat.
4) Reverse the above steps for reassembly.
NOTE : Never install the magnetron without the metallic gasket plate which is packed with each magnetron to prevent
microwave leakage. Whenever repair work is carried out on magnetron, check the microwave leakage. It shall
not exceed 4mW/cm² for a fully assembled oven with door normally closed.
Metallic
Metallic
gasket
gasket
plate
plate
Cooling fin
Cooling fin
Filament
<MAGNETRON>
terminal
Magnetron
Magnetron
antenna
antenna
Filament
terminal
<MAGNETRON>
Wave guide Magnetron antenna
Metallic gasket plate
14
Advertisement
Table of Contents
