Figure 6 Relay Output K1 (Zero-Current State); Figure 7 Pin Assignment Of The Heated Lines 3/4/5-N/M/H Or Psp-4M (-W) - M&C 701 Instruction Manual

2. Connect the mains voltage terminals identified with L1 and N to the supply voltage being sufficiently
protected by fuse.
3. Connect the switching contact for ON/OFF for the consumer to the terminals 5/6/7 with the functions NO
(normally open) / NC (normally closed) / COM (potential).

Figure 6 Relay output K1 (zero-current state)

4. Optionally, a multipole coupling socket can be mounted externally that will be wired with the temperature
controller according to the pin connection plan (see Figure 6). This enables you to make a simple, easy
servicing connection between the heated sample lines 3/4/5-N/M/H or PSP-4M (-W) by means of the
multipole coupling connector (standard equipment of the heated sample lines) with the temperature
controller.
4
5 Sensor
6 Sensor
Figure 7 Pin assignment of the heated lines
www.mc-techgroup.com
3
2 Pow er
N
1 Power
L
3/4/5- /M
N /H or PSP-4M (-W)
Temperature controller 701 | 1.01.00 11