Functional Test; Figure 9 Device Function Test With Setpoint Value Of 0 °C (Example); Figure 10 Device Function Test With Setpoint Value Of 8 °C (Example) - M&C 701 Instruction Manual

14.2

FUNCTIONAL TEST

Principally, it must be checked after the initial starting whether the controller is switching according to the adjusted
values and whether the determined operating temperature is reached.
The first function test has to be effected as follows:
1. Switch on the power supply.
2. After the set point temperature is being reached, the controller cuts the heater off  the "K1"
indicator in the display is turned off.
Figure 9 Device function test with setpoint value of 0 °C
Figure 10 Device function test with setpoint value of 8 °C
14 Temperature controller 701 | 1.01.00
[32 °F] (example)
[46.4 °F] (example)
www.mc-techgroup.com